Relay-Version: version B 2.10 5/3/83; site utzoo.UUCP
Path: utzoo!mnetor!uunet!husc6!mit-eddie!uw-beaver!tektronix!reed!psu-cs!psueea!daasch
From: daasch@psueea.UUCP (Robert Daasch)
Newsgroups: comp.lsi
Subject: Re: Spice Parameters
Message-ID: <477@psueea.UUCP>
Date: Wed, 9-Sep-87 11:50:38 EDT
Article-I.D.: psueea.477
Posted: Wed Sep  9 11:50:38 1987
Date-Received: Sat, 12-Sep-87 01:01:42 EDT
References: <2804@husc6.UUCP>
Reply-To: daasch@psueea.UUCP (Robert Daasch)
Organization: Dept. of Electrical Engineering, Portland State University; Portland OR
Lines: 16
Keywords: MOSIS, SPICE models, errors
Summary: check spice params from MOSIS

In article <2804@husc6.UUCP> clark@seraphim.harvard.edu (James J. Clark) writes:
>Spice model parameters are provided by MOSIS whenever they
...
> One should be warned, however, that sometimes these
>measurements are not too accurate and may even be way off
>(this happened to me once). So one should look at the
>parameter values closely - if they look reasonable then they
>should be alright to use. 
>
The most glaring of errors I have seen from MOSIS was a
run with CMOSP VTO > 0 and XJ = 40 centimeters!
A word to the wise...

Rob D.
..!tektronix!psueea!daasch
daasch@ee.pdx.edu.CSNET