Relay-Version: version B 2.10 5/3/83; site utzoo.UUCP Path: utzoo!utgpu!water!watmath!clyde!rutgers!ames!sdcsvax!ucsdhub!hp-sdd!hplabs!hp-pcd!uoregon!omepd!littlei!ogcvax!schaefer From: schaefer@ogcvax.UUCP Newsgroups: comp.sources.wanted Subject: Re: Parallel Make Message-ID: <1383@ogcvax.UUCP> Date: Sat, 15-Aug-87 16:19:09 EDT Article-I.D.: ogcvax.1383 Posted: Sat Aug 15 16:19:09 1987 Date-Received: Tue, 18-Aug-87 01:34:35 EDT References: Reply-To: schaefer@ogcvax.UUCP (Barton E. Schaefer) Distribution: comp Organization: Oregon Graduate Center, Beaverton, OR Lines: 18 Summary: Sequent DYNIX has one; is there one for UN*X? In article murthy@dopey.cs.cornell.edu (Chet Murthy) writes: >Does anybody out there have a parallel Make program? I am looking >for something which takes a list of machines which share a common filesystem, >and then forks parallel steps of the make via rsh or something, to >achieve parallel execution. > Something like this is available in DYNIX from Sequent, running on the Balance. I'd like to see it running under UN*X on a dear old Vax 780; the heck with forking the parallel steps to other processors/machines, just fork 'em. Anybody have such a beast? -- Bart Schaefer Dept. of CS&E CSNET: schaefer@Oregon-Grad Oregon Graduate Center UUCP: {ihnp4,seismo,sun}!verdix \ 19600 NW Von Neumann Dr {hplabs,ucbvax,decvax}!tektronix !ogcvax!schaefer Beaverton, OR 97006