Relay-Version: version B 2.10 5/3/83; site utzoo.UUCP
Path: utzoo!mnetor!uunet!seismo!rutgers!ukma!psuvm.bitnet!j5u
From: J5U@PSUVM.BITNET
Newsgroups: comp.sys.att
Subject: Need Help using 6300 as server in 3com ethernet
Message-ID: <18925J5U@PSUVM>
Date: Mon, 24-Aug-87 18:06:29 EDT
Article-I.D.: PSUVM.18925J5U
Posted: Mon Aug 24 18:06:29 1987
Date-Received: Wed, 26-Aug-87 04:48:32 EDT
Organization: The Pennsylvania State University - Computation Center
Lines: 20

I'm using a PC 6300 as a server on a 3com ethernet that I just installed
I'm using 3com Etherseries software and 3c501 boards(half-cards). The
network works ok, or it did, but recently I tried hooking a HP Laserjet II
to the server in Com1 and reconfigured the software to use the HP LaserJet
as printer 2 on the network. All went well till I tried to print something
of on the laserjet and then would never print, the output would be routed into
the printer queue and there it would stay. I think I finially have figured
out what could be wrong with it, but don't know what to do about it. I think
that I am either having an interrupt conflict with or possiblly an Addressing
conflict on the I/O. Could someone tell me what interuppt is the COm1 port
of the Pc 6300. Or am I completely wrong with my assumptions and should
start over someplace else? Any help that could be sent my way would be
deeply appreciated..
     
     
     
     
                            Leon Geesey
                        j5u@psuvm.bitnet