Relay-Version: version B 2.10 5/3/83; site utzoo.UUCP
Path: utzoo!utgpu!water!watmath!clyde!cbosgd!ihnp4!inuxc!iuvax!pur-ee!uiucdcs!uiucdcsb!kkim
From: kkim@uiucdcsb.UUCP
Newsgroups: comp.sys.mac
Subject: help needed: CODE vs. PROC resource
Message-ID: <164500052@uiucdcsb>
Date: Thu, 27-Aug-87 21:58:00 EDT
Article-I.D.: uiucdcsb.164500052
Posted: Thu Aug 27 21:58:00 1987
Date-Received: Sat, 29-Aug-87 17:43:03 EDT
Lines: 28
Nf-ID: #N:uiucdcsb:164500052:000:1154
Nf-From: uiucdcsb.cs.uiuc.edu!kkim    Aug 27 20:58:00 1987


   i tried to combine an application and resources for it using RMaker
(version 2.0D2, 1/29/86).  there was no problem when i compiled resources
other than an application code.  when i tried to include an application code,
RMaker would not accept it.  i tried a couple of ways without any success.

   when i tried 'TYPE CODE', RMaker said 'unknown type'.  when i tried
'TYPE PROC', it said 'bad object definitions'.  what is wrong here?

in lightspeed pascal, there is a run option which allows me to specify a
resource file and i succeeded in combining them.  however, i want to know
how to do it in general using RMaker.

   BTW, what is the difference between  CODE and PROC resource types?
i know that CODE is a predefined resource type.  is PROC also predefined?
which of the two do i have to use to include an application code?

   also i would like to know where/how i can get a good document about RMaker
and RedEdit/REdit.

   any help will be appreciated.  thanks in advance.

kyongsok kim

dept. of computer science; univ. of illinois at urbana-champaign

arpanet/csnet: kkim@b.cs.uiuc.edu
usenet/uucp  : {seismo, pur-ee, ihnp4}!uiucdcs!kkim