Relay-Version: version B 2.10 5/3/83; site utzoo.UUCP Path: utzoo!utgpu!water!watmath!clyde!rutgers!husc6!ut-sally!utah-cs!smittys!hpai From: hpai@smittys.UUCP Newsgroups: comp.sys.mac Subject: Re: MacTerminal 2.2 problem Message-ID: <4932@utah-cs.UUCP> Date: Wed, 2-Sep-87 11:52:34 EDT Article-I.D.: utah-cs.4932 Posted: Wed Sep 2 11:52:34 1987 Date-Received: Fri, 4-Sep-87 01:43:44 EDT References: <7195@ism780c.UUCP> Sender: news@utah-cs.UUCP Reply-To: hpai%smittys.UUCP@utah-cs.UUCP (HP AI User) Distribution: world Organization: Univ of Utah CS Dept Lines: 29 In article <7195@ism780c.UUCP> darryl@ism780c.UUCP (Darryl Richman) writes: >I'm having a problem with MacTerminal 2.2. I recently upgraded >my Mac+ to 4.1/5.3 and obtained the 2.2 version of MacTerminal. >However, MacTerminal now complains "This document is incompatible >with this version of MacTerminal", even when open the application >itself! Yes, I noticed this strange behavior too. The fix is fairly simple. Pull out your old MacTerminal 2.0 and create a MacTerminal document with it. Believe it or not, MacTerminal 2.2 recognizes 2.0 documents, but not its own! It does put its signature onto NEW documents, but not onto old ones. In other words, you can save settings onto a 2.0 document and MacTerminal 2.2 will still accept it! (If any replies are to be sent, send to u-cdmorr@ug.utah.edu) ----------------------------------------------------------------------- Disclaimer: I claim dis viewpoint. I welcome discussion and comments because, after all, what good is an opinion if you can't change it!!! ----------------------------------------------------------------------- ___ | USPS / | ~ |\ |\ /|/|/| ~ | Clifford Morrison | | | || || | | | /\ |/ |/ | /\ /\ |/| | 2950 Upland Drive `___ | | |/ |/ | | | \/ | | | / ) \/ | | | Salt Lake City, UT |\ |\ | 84109 |/ |/ u-cdmorr@ug.utah.edu!cs.utah.edu | GENIE C.D.MORRISON -----------------------------------------------------------------------