Relay-Version: version B 2.10 5/3/83; site utzoo.UUCP
Path: utzoo!mnetor!uunet!husc6!bloom-beacon!oberon!cit-vax!elroy!mahendo!jplgodo!wlbr!scgvaxd!trwrb!cadovax!gryphon!jdow
From: jdow@gryphon.CTS.COM (Joanne Dow)
Newsgroups: comp.sys.amiga
Subject: Re: C/Assembly Help
Message-ID: <1751@gryphon.CTS.COM>
Date: Sat, 3-Oct-87 02:59:21 EDT
Article-I.D.: gryphon.1751
Posted: Sat Oct  3 02:59:21 1987
Date-Received: Wed, 7-Oct-87 01:36:50 EDT
References: <18009@aero.ARPA>
Reply-To: jdow@gryphon.CTS.COM (Joanne Dow)
Organization: Wizardess Designs
Lines: 24

In article <18009@aero.ARPA> foy@aero.UUCP (Richard Foy) writes:
>
>
>What do I have to do to asseble the assembly code? Do I have to make this
>into an assembly module with ref def statements and asseble it seperately
>and then link it with the rest of the program. Or is there some when of
>calling the assembler when I run the C compile functions.
>
It seems that is impossible. Lattice C does not have an assembler pass.
You have to make it a separate module and link it in.

>Thanks for any help.
>
>Richard Foy


-- 
<@_@>
	BIX:jdow
	INTERNET:jdow@gryphon.CTS.COM
	UUCP:{akgua, hplabs!hp-sdd, sdcsvax, ihnp4, nosc}!crash!gryphon!jdow

Remember - A bird in the hand often leaves a sticky deposit. Perhaps it was
better you left it in the bush with the other one.