Relay-Version: version B 2.10 5/3/83; site utzoo.UUCP
Path: utzoo!mnetor!uunet!husc6!rutgers!mcnc!ecsvax!mvolo
From: mvolo@ecsvax.UUCP (Michael R. Volow)
Newsgroups: comp.sys.ibm.pc
Subject: Re: Isn't Parity a Hardware Concept?
Message-ID: <3962@ecsvax.UUCP>
Date: Sat, 3-Oct-87 08:51:28 EDT
Article-I.D.: ecsvax.3962
Posted: Sat Oct  3 08:51:28 1987
Date-Received: Wed, 7-Oct-87 00:57:53 EDT
References: <811@cup.portal.com>
Organization: UNC Educational Computing Service
Lines: 13
Summary: Fastback blowing up on Zenith 200 series - me too!



We also had the same problem of Fastback blowing up on a Zenith 200
series AT clone, with the same "+++++ parity error" message.  Fast-
back loaded, began to run, and then zingo!!!  We don't know if this
is a Zenith problem or a Fastback problem.  I had the same problem
when I tried to run CopyIIpc (Central Point).  There has been a 
problem with Zenith's EMS board, but it was not in the machine at the
time.

--Mike Volow, Psychiatry, Durham Veterans Administration Medical Center
  Durham, NC, 27712             919 383 3568
  mvolo@ecsvax.UUCP