Relay-Version: version B 2.10 5/3/83; site utzoo.UUCP
Path: utzoo!mnetor!uunet!husc6!hao!ames!amdcad!decwrl!cesare.dec.com!zabot
From: zabot@cesare.dec.com (Adv.Tech.Mgr-ACT Torino)
Newsgroups: comp.sys.amiga
Subject: Aegis Drwa Plus problems: parts disappear  ??!!
Message-ID: <11948@decwrl.DEC.COM>
Date: Fri, 23-Oct-87 19:33:00 EST
Article-I.D.: decwrl.11948
Posted: Fri Oct 23 19:33:00 1987
Date-Received: Sun, 25-Oct-87 16:08:37 EST
Sender: daemon@decwrl.DEC.COM
Organization: Digital Equipment Corporation
Lines: 25

VENERE::ZABOT "Marco Zabot-Adv.Tech.mgr-Turin ACT"   
--------------------------------------------------------------------------------

    I'm having problems using Aegis Draw Plus, V.2.0.

    While drawing I create Parts by grouping and naming different
    pieces together. If then I can try to use again them ( F10 or EDIT PART)
    I got the correct list of Parts in Stock but then I place them on
    a RANDOM base only ( I have not been able to discover the mechanism
    governing it ) 'cause MOST of the times I get the message
    	Can't find part.
    I have also tried to create a PART DIRECTORY. It works well, the
    data are there and are correct. After loading them same as above.
    
    The strange is that a part suddenly (?) becomes available and then
    disappears again. 

    I have tried to run DrawPlus through FixHunk ( you never know !). No
    good. 
    
    Furthermore, what's the way of deleting a Part that you don't
    want any more ???

    Any Help Warmly Welcomed !
    Marco