Relay-Version: version B 2.10 5/3/83; site utzoo.UUCP
Path: utzoo!mnetor!uunet!seismo!sundc!pitstop!sun!amdcad!ames!ucbcad!ucbvax!UKANVAX.BITNET!2QZNHONE
From: 2QZNHONE@UKANVAX.BITNET
Newsgroups: comp.sys.apple
Subject: SuperSonic from MDIdeas
Message-ID: <8710272334.aa01843@SMOKE.BRL.ARPA>
Date: Tue, 27-Oct-87 12:38:00 EST
Article-I.D.: SMOKE.8710272334.aa01843
Posted: Tue Oct 27 12:38:00 1987
Date-Received: Tue, 3-Nov-87 05:48:40 EST
Sender: usenet@ucbvax.BERKELEY.EDU
Organization: The ARPA Internet
Lines: 19

I just purchased the SuperSonic Stereo card for the IIGS and the SuperSonic
Digitizer add-on board.  Everything worked great when I plugged in the
Stereo card.  Then I went on to using the Digitizer and I ran into a problem.
I had already input a sound from my Sony Walkman and it was saved on disk.
I selected Playback Mono after the sound had been loaded and the sound came
out both speakers.  When I selected Playback Mono again it ONLY played out
one of speakers.  What is going on?  To make a long story short, when you
load the Digitizer Sound Editor it says Loading Ram based Tools.......
If you have the new ROM upgrade on your computer you must load the System
Disk 3.1 first then run the Digitizer Sound Editor from System Disk 3.1

This takes care of the problem.  I'm not really sure why though.  Does the
System Disk 3.1 have patches for the New ROM?  Does the new ROM have problems
This is just information for you all that will probably purchase the
SuperSonic Stereo Card and the SuperSonic Digitizer.  Have fun!!!!

Todd Smith
University of Kansas
2QZNHONE@UKANVAX.BITNET