Relay-Version: version B 2.10 5/3/83; site utzoo.UUCP
Path: utzoo!utgpu!water!ljdickey
From: ljdickey@water.UUCP
Newsgroups: comp.sys.atari.st
Subject: Re: FLASH TELECOMMUNICATIONS PROGRAM
Message-ID: <1169@water.waterloo.edu>
Date: Thu, 15-Oct-87 08:24:59 EDT
Article-I.D.: water.1169
Posted: Thu Oct 15 08:24:59 1987
Date-Received: Sat, 17-Oct-87 14:03:12 EDT
References: <1696@homxc.UUCP>
Reply-To: ljdickey@water.waterloo.edu (Lee Dickey)
Organization: U. of Waterloo, Ontario
Lines: 20

In article <1696@homxc.UUCP> jdn@homxc.UUCP (J.NAGY) writes:
> How do you drop the carrier from within FLASH?
> 
> After I've logged off a BBS or Compuserve, I can't figure out to
> drop the line other than powering down the modem.  ....

I think this is a question about the Modem, and not about the
communications program...  Maybe you could try

	1) type "+++"  (without RETURN )
	2) wait a few seconds for the "OK" to appear, and 
	3) then type  "ATH"  and RETURN to tell the modem to hang up.

This sequence works with Hayes and so-called "Hayes compatible" modems.

-- 
 L. J. Dickey, Faculty of Mathematics, University of Waterloo. 
 ljdickey@watmath.UUCP		UUCP: ...!uunet!watmath!ljdickey
 ljdickey%water@waterloo.edu	ljdickey@watdcs.BITNET		
 ljdickey%water%waterloo.csnet@csnet-relay.ARPA