Relay-Version: version B 2.10 5/3/83; site utzoo.UUCP Path: utzoo!mnetor!uunet!husc6!rutgers!iuvax!franco From: franco@iuvax.cs.indiana.edu Newsgroups: comp.sys.atari.st Subject: ETERNAL RD for SPLAST Message-ID: <36500022@iuvax> Date: Fri, 23-Oct-87 08:58:00 EST Article-I.D.: iuvax.36500022 Posted: Fri Oct 23 08:58:00 1987 Date-Received: Sun, 25-Oct-87 15:45:58 EST Organization: Indiana University CSCI, Bloomington Lines: 46 Nf-ID: #N:iuvax:36500022:000:2089 Nf-From: iuvax.cs.indiana.edu!franco Oct 23 07:58:00 1987 Here is a copy of eternal that works with splast (see earlier note). Operation: Set size and ramdisk id on bootup or restart by holding down the alternate key until a prompt appears. Then type the ramdisk spec ( e.g. m300 gives a 300k ramdisk on drive m, d2 gives a 2k ramdisk on drive d, etc.). To resize, hit reset and follow the instructions above. Remove ramdisk completely by pressing reset then left-shift during the entire restart (using alt and typing d0 just creates a size 0 ramdisk at a cost of 2600 bytes). Default ramdisk spec is m200. Here is the program (using dumas uuencode). Name it eternal2.uue and use the dumas uudecoder (early version). table !"#$%&'()*+,-./0123456789:;<=>? @ABCDEFGHIJKLMNOPQRSTUVWXYZ[\]^_ begin 644 eternal2.prg M8!H ,F , @8 "I/+GP 5:*FT !" M S0z MK0 4T*T '-"\ ! "\ +PT_/ /SP 2DY!W_P ,0J<_/ @3D%D;D 0Vq MD;D 0N(_D 1R #""/Y $=@ Q0C^0 !'X ,.('P )2(E5^p M?R+84<___"X\ 1 "+\ %'/__@@>0 1.T"(5TKP @(\$ 1Ro M(A72O #(CP0 !'8B%=*\ $B/! $?B!5T?P #&,A P.0 !,0#n MP#/ $Q"!5T?P 0,+P "\Y #&C\\ "!.05R/0F=.00( ($ 'm M 4 !@ 2 &0 QO P !&8 *!P $YU#&\ # $9@ C" Y $+DYU#&\ l M# .9@ AB!Y $+M'\ " ")O 9R #(O QP">&AT<$P+P *) D( @ k M9B@(+P 5F L%),CP #R#9(-D@V2#9(-D@V2#9(-E1R?_N4X!FY$YU""\ j M %9@+!23(\ #\0V1#9$-D0V1#9$-D0V1#94