Relay-Version: version B 2.10 5/3/83; site utzoo.UUCP
Path: utzoo!mnetor!uunet!husc6!hao!boulder!sunybcs!rutgers!mcnc!ncsuvx!jck
From: jck@ncsuvx.ncsu.edu (Chuck Kesler)
Newsgroups: comp.sys.amiga
Subject: Re: Many subjects...
Message-ID: <1245@ncsuvx.ncsu.edu>
Date: Thu, 12-Nov-87 18:42:29 EST
Article-I.D.: ncsuvx.1245
Posted: Thu Nov 12 18:42:29 1987
Date-Received: Sat, 14-Nov-87 21:27:38 EST
References: <6463@sunybcs.UUCP> <16427@topaz.rutgers.edu>
Reply-To: jck@ncsuvx.UUCP (Chuck Kesler)
Organization: NCSU Computing Center, Raleigh, NC
Lines: 26

In article <16427@topaz.rutgers.edu> lachac@topaz.rutgers.edu (Gerard Lachac) writes:
>In article <6463@sunybcs.UUCP> ugpete@sunybcs.UUCP (Peter Theobald) writes:
>
>>2)	When I run two programs (specifically VT100 and DirMaster) that
>>	each open their own screens, once I look at VT100, I can't get
>>	back to the DirMaster screen! The VT100 window takes up the full
>>	screen and cannot be re-sized, so I cannot reach the Front/Back
>>	gadgets. The A-N A-M will only switch me from Workbench to VT100.
>
>This is a lot easier then it sounds.  Use the A-N A-M to get to the 
>Workbench screen, and then use the Workbench's forward and back gadgets to
>get to the Dirmaster screen.

Even easier method:  pull the Vt100 window down slightly, so that you just
barely expose the front/back gadgets on the Vt100 *screen*.  By clicking
the very top part of these gadgets, you can pop back to the workbench, and go
wherever else you want to go from there.  

-chuck      jck@ncsuvx.ncsu.edu  -or-  chuck@ncsuvm.BITNET
*
*
*
*  Yes Virginia, there is a line eater!
*
*
*