Relay-Version: version B 2.10 5/3/83; site utzoo.UUCP
Path: utzoo!mnetor!uunet!husc6!rutgers!cbmvax!grr
From: grr@cbmvax.UUCP (George Robbins)
Newsgroups: comp.sys.amiga
Subject: Re: CBM and upgrade paths
Message-ID: <2765@cbmvax.UUCP>
Date: Sat, 14-Nov-87 03:05:24 EST
Article-I.D.: cbmvax.2765
Posted: Sat Nov 14 03:05:24 1987
Date-Received: Sun, 15-Nov-87 17:21:16 EST
References: <8711040542.AA29099@violet.berkeley.edu>
Reply-To: grr@cbmvax.UUCP (George Robbins)
Organization: Commodore Technology, West Chester, PA
Lines: 25
Keywords: Colt 45.  Not the lager.

In article <3338@xanth.UUCP> kent@xanth.UUCP (Kent Paul Dolan) writes:
> In article <2721@cbmvax.UUCP> grr@cbmvax.UUCP (George Robbins) writes:
> >There really should be a couple holes over the trimmer cap and TP3 to
> >make adjustment simple, but I was still busy trying to get the board
> >layout done and thru FCC to keep a close eye on the mechanical people
> >that did the shields.  Maybe we can do something about it, but it would
>                         ^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^
> >take months for the holes to show up in your dealer.
>  ^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^
> 
> I know there's been a little discontent about some Amiga dealers
> (ignorance of the hardware, backorders, lack of service, etc.)
> expressed on the net, but I really think this is a bit extreme.

	Well, make that "at your dealer" or "on your dealers shelves" -
The point I was really trying to make was that the pipeline from the
metal fabrication shop to dealer's shelves in many months long and
this isn't exactly an emergency issue...
 
> Besides, why wait months?  Any Saturday night special will do the job
> in fractions of a second.  ;-)
-- 
George Robbins - now working for,	uucp: {ihnp4|rutgers|allegra}!cbmvax!grr
but no way officially representing	arpa: out to lunch...
Commodore, Engineering Department	fone: 215-431-9255 (only by moonlite)