Relay-Version: version B 2.10 5/3/83; site utzoo.UUCP Path: utzoo!mnetor!uunet!husc6!cmcl2!rutgers!rochester!PT.CS.CMU.EDU!cadre!pitt!cisunx!jmp From: jmp@cisunx.UUCP (Jon M Pearsall) Newsgroups: comp.sys.apple Subject: Re: problems with executioner files Message-ID: <5365@cisunx.UUCP> Date: Sun, 15-Nov-87 17:06:04 EST Article-I.D.: cisunx.5365 Posted: Sun Nov 15 17:06:04 1987 Date-Received: Tue, 17-Nov-87 02:13:37 EST References: <3152@husc6.UUCP> Reply-To: jmp@unix.cis.pittsburgh.edu.UUCP (Jon M Pearsall) Organization: Univ. of Pittsburgh, Comp & Info Sys Lines: 28 In article <3152@husc6.UUCP> nakada@husc4.UUCP (paul nakada) writes: > >i downloaded a few of the executioner encoded files from the file >server and then 'exec'd them. everything seemed to go fine, but upon >executing them, i drop into the monitor. there appears to be garbage >at $1000 (there is garbage there) where execution is supposed to >begin. In fact, i can't seem to find any executable code in the area >of memory in which the program resides. ....... Try changing the file type parameter or the beginning memory location. I've found that many of the programs from the listserv (or executioner in general I suppose) will not run after they are exec'ed. Often time the problem is a matter of just changing the beginning address of the file from $1000 to $2000 or visa-versa. Just look at a complete CATALOG to see what it is presently. Other times it is a matter of changing the file type from BIN to SYS. Apparently executioner goofs up a little when packing a file (or perhaps the translation gets lost in transfer). Anyways, there is a nice little program on the listserv called Change File Type which will help you in doing these changes. Luckily, it execs just swell. Jon -- =-=-=-=-=-=-=-=-=-= Jon Pearsall, University of Pittsburgh =-=-=-=-=-=-=-=-=-= = !pitt!cisunx!jmp As the Zorg closes in, Spaceman Spiff = = jmp@unix.cis.pittsburgh.edu cooly draws his death ray blaster. = =-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=