Relay-Version: version B 2.10 5/3/83; site utzoo.UUCP
Path: utzoo!mnetor!uunet!husc6!rutgers!labrea!jade!ucbvax!OUACCVMB.BITNET!CS656
From: CS656@OUACCVMB.BITNET
Newsgroups: comp.sys.apple
Subject: Note to Ted Medin
Message-ID: <8711131628.aa10680@SMOKE.BRL.ARPA>
Date: Fri, 13-Nov-87 14:51:57 EST
Article-I.D.: SMOKE.8711131628.aa10680
Posted: Fri Nov 13 14:51:57 1987
Date-Received: Tue, 17-Nov-87 06:13:23 EST
Sender: daemon@ucbvax.BERKELEY.EDU
Organization: The ARPA Internet
Lines: 19


Hello Ted Medin,
I hope that posting these messages here is ok, as I'm not sure of
how to reach your mailbox.  KERMIT 3.80 works perfectly with my
/RAMcard.  This is extemely handy as I had been in the habit of
loading once in the evening and switching from /RAM.  Up/downloading
from /RAM seems to be a bit quicker, too. I have a ton of software,
Kermit, however, is my most important program.
Thanks,
Bob Church
P.S. Would it be possible to add a TTY mode? The mainframe here
defaults to TTY if you are not using VT100.  The sync bytes that
it generates are incompatible with APPLE//C 80 COLUMN firmware,
causing reverse scrolling, etc.  When configuring the //C as a terminal
(using no software) I can solve this problem by using the ESCAPE-CONTROL-D
sequence but this doesn't help when running KERMIT. When not using VT100
I have to use 40 column. I can send specifics as to the codes that need
filtered if you like.
.