Relay-Version: version B 2.10 5/3/83; site utzoo.UUCP
Path: utzoo!mnetor!uunet!lll-winken!csustan!csun!abcscnge
From: abcscnge@csun.UUCP (Scott Neugroschl)
Newsgroups: comp.sys.ibm.pc
Subject: Question about Xebec HD controller
Message-ID: <879@csun.UUCP>
Date: Mon, 9-Nov-87 21:30:34 EST
Article-I.D.: csun.879
Posted: Mon Nov  9 21:30:34 1987
Date-Received: Thu, 12-Nov-87 03:19:28 EST
Reply-To: abcscnge@csun.UUCP (Scott Neugroschl)
Distribution: na
Organization: California State University, Northridge
Lines: 15
Keywords: Xebec HD


We are trying to install a second hard disk in a true-blue IBM XT.  We
have 2 10 MB hard disks, 2 Xebec controllers.  We would like to install
both HD's on one controller, but we don't have the proper cabling, so we
are going to use 2 controller boards.  Our problem is this:  our in-house
technical support at work doesn't have the documentation, so when we install
both boards into our PC, they are both at the same I/O address and ROM address,
thereby causing an obvious contention lockup when drive C is accessed.  How
do we set the ROM ADDR, I/O ADDR and OPTION jumpers to configure one drive
and controller as C and the other as D?

Thanks in advance...
-- 
Scott "The Pseudo-Hacker" Neugroschl
UUCP: {litvax,humboldt,sdcrdcf,rdlvax,ttidca,}\_ csun!abcscnge
      {psivax,csustan,nsc-sca,trwspf         }/