Relay-Version: version B 2.10 5/3/83; site utzoo.UUCP
Path: utzoo!utgpu!water!watmath!clyde!rutgers!princeton!phoenix!buzz
From: buzz@phoenix.UUCP
Newsgroups: comp.sys.mac
Subject: Re: Installer 2.5 glitches
Message-ID: <1157@phoenix.Princeton.EDU>
Date: Thu, 19-Nov-87 14:10:00 EST
Article-I.D.: phoenix.1157
Posted: Thu Nov 19 14:10:00 1987
Date-Received: Sat, 21-Nov-87 15:53:01 EST
References: <18374@amdahl.amdahl.com> <174400075@uxc.cso.uiuc.edu>
Reply-To: buzz@phoenix.UUCP (Mahboud Zabetian)
Organization: Advanced Technology, Princeton University
Lines: 25

In article <174400075@uxc.cso.uiuc.edu> dorner@uxc.cso.uiuc.edu writes:
>
>(This is a flame.)
>
>Once you have installed the new system on your hard disk, run the installer
>FROM THE HARD DISK to install onto floppies.  This will work.
>
>Those of you with just a single floppy drive--don't use the Installer.

There is a BIG problem with installing from the hard disk.  After I had my
system set up on the hard disk, I went ahead and tailored the System file to my
needs, i.e. I took the calculator and alarm clock DAs out, and also removed a 
bunch of fonts.

When I went ahead to install a system onto a floppy, I got errors to the effect
of: 'RSRC error; driver alarm clock not found'.  I replaced the alarm clock and
did the whole thing over again; this time I was told that the calculator wasn't
found.  Next I was told that FOND Courier wasn't found.

Could someone tell me why the installer needs those resources?
-- 
Mahboud Zabetian				buzz@phoenix.princeton.edu
183 Little Hall 					(609) 520-1270
Princeton University					(609) 734-7760
Princeton, NJ 08544				buzz@issun.princeton.edu