Relay-Version: version B 2.10 5/3/83; site utzoo.UUCP
Path: utzoo!mnetor!uunet!ukma!psuvm.bitnet!cunyvm!byuvax!taylorj
From: taylorj@byuvax.bitnet
Newsgroups: comp.sys.mac
Subject: RE: Parallel Daisy-wheel on Mac SE
Message-ID: <40taylorj@byuvax.bitnet>
Date: Wed, 18-Nov-87 21:45:05 EST
Article-I.D.: byuvax.40taylorj
Posted: Wed Nov 18 21:45:05 1987
Date-Received: Sun, 22-Nov-87 02:51:45 EST
Lines: 17

This may not be any more helpful than the previous lack of response, but
I'll tell you what I know.

A daisy-wheel printer driver was just posted to comp.mac.binaries a few
days ago.  It should solve half of your problem.  For the other half, MicroSoft
used to sell an expansion chassis for the Mac that had parallel ports on
it.  They don't sell it any more, but could probably tell you who does
(it might be Assimilation).  Orange Micro just announced a Grappler for
the Mac.  I believe it's designed for Epsons, but maybe has a "generic"
mode that would just do a plain serial->parallel conversion.  Protecto
Enterprises at one point had serial->parallel converters.

Jim Taylor
Microcomputer Support for Curriculum, Brigham Young University
taylorj@byuvax.bitnet