Relay-Version: version B 2.10 5/3/83; site utzoo.UUCP
Path: utzoo!mnetor!uunet!husc6!cca!mirror!ishmael!inmet!ian
From: ian@inmet.UUCP
Newsgroups: comp.sys.mac
Subject: 1st Base problem
Message-ID: <127200011@inmet>
Date: Fri, 20-Nov-87 11:59:00 EST
Article-I.D.: inmet.127200011
Posted: Fri Nov 20 11:59:00 1987
Date-Received: Tue, 24-Nov-87 04:45:24 EST
Lines: 9
Nf-ID: #N:inmet:127200011:000:441
Nf-From: inmet.UUCP!ian    Nov 20 11:59:00 1987


I'm having a problem with First Base.  I created a file,
copied it to a back-up disk, then later copied it onto the
First Base disk again.  The file blueprint was corrupted.
(This is reproducable.)  I checked the disk and found that
all the data was there but I cannot access it because the
Blueprint is incorrect and even if I go in and correct the
Blueprint (from 1st Base) the changes don't stick (the
Blueprint stays corrupted).  Help?!