Relay-Version: version B 2.10 5/3/83; site utzoo.UUCP
Path: utzoo!mnetor!uunet!husc6!rutgers!mcnc!ece-csc!ncrcae!ncr-sd!hp-sdd!ucsdhub!sdcsvax!ucbvax!DOCKMASTER.ARPA!MSchwartz
From: MSchwartz@DOCKMASTER.ARPA
Newsgroups: comp.sys.zenith.z100
Subject: Programs that run under ZPC
Message-ID: <871120150300.596985@DOCKMASTER.ARPA>
Date: Fri, 20-Nov-87 10:03:00 EST
Article-I.D.: DOCKMAST.871120150300.596985
Posted: Fri Nov 20 10:03:00 1987
Date-Received: Sun, 22-Nov-87 14:58:33 EST
Sender: daemon@ucbvax.BERKELEY.EDU
Organization: The ARPA Internet
Lines: 15

I have found several programs that run under ZPC (monochrome version --
I do not have a Scotty board).
  Edix versions 3, 4, 5, and 6.  I have not successfully patched them (yet) to
    handle color.  However, since I completed a MicroEmacs 3.8i port, I use
    this editor only rarely.
  Flexicon (laser wordix).  Even the GEM CGA driver works for this.  This
    program will not install itself without ZPC running.  A few quirks in
    ZPC V2 are exposed by the installation (apparently the NUL device "vanishes"
    ).  The program can import GEM or PaintBrush graphics (with some limitations).
    Emerging Technologies was kind enough to send me the specs for PB files.
  Wordix.  This program works fine without ZPC if you are only doing file or
    printer output.  For screen previews, ZPC does well.  I have upgraded my
    version from very early on, so I have used most versions of this product.

Hope this info may be useful....  mike (MSchwartz -at DOCKMASTER)