Path: utzoo!utgpu!water!watmath!clyde!cbosgd!mandrill!hal!ncoast!obroin@hslrswi.UUCP
From: obroin@hslrswi.UUCP (Niall O'Broin)
Newsgroups: comp.sources.wanted
Subject: microEmacs 3.9 on IBM-PC with MSC
Keywords: microEmacs MSC PC-DOS
Message-ID: <6401@ncoast.UUCP>
Date: 11 Dec 87 02:31:56 GMT
Sender: allbery@ncoast.UUCP
Organization: Hasler AG, CH-3000 Berne 14, Switzerland
Lines: 22

The recent posting of microEmacs 3.9 sources came with makefiles for Unix
and Mark Williams C on Atari ST. Does anyone have a makefile suitable for
use with MicroSoft C and NDMAKE ? Also, what identifiers should be defined
before compilation for IBM-PC for correct paths through IFDEFs ?

Yes, I know all this is none too difficult, but I'm sure someone else has
already done it, and I HATE re-inventing the wheel.

Regards and thanks in advance,

       #\\\\\-----\\\\\       Niall  O Broin
      ###\\\\\-----\\\\\      AXE Software Development
     #####---------------     Hasler AG      +-----------------------------+
    #######---------------    Berne          +This space available for rent|
   #########\\\\\-----\\\\\   Switzerland    +-----------------------------+
  ###########\\\\\-----\\\\\
 #######     /////     /////  BITNET       obroin%hslrswi.UUCP@cernvax.BITNET
#######     /////     /////   UUCP .. {uunet,mcvax ..}!cernvax!hslrswi!obroin
 #####               /////    Voice telephone +41 31 631701 08.30-17.30 C.E.T.
  ###               /////     Any resemblance between this message and the
   #     /////     /////      opinions of anyone else, living or dead, is
        /////     /////       purely coincidental.