Path: utzoo!mnetor!uunet!husc6!hao!ames!oliveb!amiga!cbmvax!schein From: schein@cbmvax.UUCP (Dan Schein CATS) Newsgroups: comp.sys.amiga Subject: Re: A2000 lockup Message-ID: <2978@cbmvax.UUCP> Date: 21 Dec 87 14:37:37 GMT References: <2260@tekig4.TEK.COM> Reply-To: schein@cbmvax.UUCP (Dan Schein CATS) Organization: Commodore Technology, West Chester, PA Lines: 32 Keywords: A2000 bridge jh0 lockup In article <2260@tekig4.TEK.COM> brianr@tekig4.TEK.COM (Brian Rhodefer) writes: >I am having some difficulties with my A2000/Bridgeboard system >that I'd very much appreciate some helpful advice on. > >I have a hard disk attached to the IBM bridge card, with an Amiga partition >for use as JH0. After activating "PCMono" via the Workbench, the Amiga >seems to loose its ability to access its partition (JH0:) on the bridge's >hard disk; any CLI or Workbench control input which requires access to >JH0: "hangs". This lockup doesn't always happen immediately after opening >the IBM window, but does happen within a very few IBM command executions. >The IBM window still works, even after the Amiga windows are hung up. > >Is this a common problem? Have I done something stupid? > >Pre-gratefully, > >Brian Rhodefer In my pre 2000 days I ran a 1000 with SideCar and a 20meg hardcard that I had partitioned for 2meg MS-DOS and 18meg AmigaDOS. I never lost my JH0: partion when I started the PCWindow program (IE: PCMono or PCColor). So I think you may have done something wrong because that is not a common problem. -- Dan Schein uucp: {ihnp4|allegra|burdvax|rutgers}!cbmvax!schein Commodore AMIGA Bix: dschein Plink: Dan*CATS 1200 Wilson Drive phone: (215) 431-9100 ext. 9542 West Chester PA 19380 +----------------------------------------------------------------------------+ All spelling mistakes are a result of my efforts to avoid education :-) +----------------------------------------------------------------------------+ I help Commodore by supporting the AMIGA. Commodore supports me by allowing me to form my own suggestions and comments.