Path: utzoo!mnetor!uunet!husc6!bloom-beacon!gatech!hao!oddjob!gargoyle!ihnp4!homxb!hropus!ki4pv!codas!burl!clyde!feg
From: feg@clyde.ATT.COM (Forrest Gehrke)
Newsgroups: comp.sys.ibm.pc
Subject: Re: Need Clock reading prog for Leading Edge Model D
Message-ID: <18687@clyde.ATT.COM>
Date: 18 Dec 87 13:12:46 GMT
References: <651@pdp.cs.OHIOU.EDU> <908@maccs.UUCP>
Organization: AT&T Bell Labs, Whippany, NJ
Lines: 25
Keywords: clock leading edge pc
Summary: No cigar!

In article <908@maccs.UUCP>, darel@maccs.UUCP (Darel Mesher) writes:
> In article <651@pdp.cs.OHIOU.EDU> shapiro@oucs.UUCP writes:
> >
> >
> >I have recently installed a new 30MB drive into my fathers Leading Edge
> >model D. When I installed his new version of MS-DOS 3.2 (not IBM PC-DOS)
> >I found that his clock is no longer read automatically at boot up.
> > 
> >Brian.
> 
>    Since the Leading Edge PC and the SPERRY PC are the same Mitsubishi box 
> marketed by two different corporations, the following utility should work
> without modification.


Sorry Darel---You missed "Model D".  That is a Korean job, not the
Model M (for Mitsubishi).  The code is different and I doubt very 
much your clock setting routines will work.  

Brian's father, on the other hand, must have installed an ms-dos 
version not specific to the Model D.  He'd best get what he needs
from Leading Edge, i.e. if they still support the Model D.  They
orphaned us poor Model M users.

Forrest Gehrke