Path: utzoo!mnetor!uunet!husc6!rutgers!mtune!codas!killer!dons
From: dons@killer.UUCP (Don Simoneaux)
Newsgroups: comp.sys.ibm.pc
Subject: Re: Need Clock reading prog for Leading Edge Model D
Message-ID: <2514@killer.UUCP>
Date: 19 Dec 87 17:06:39 GMT
References: <651@pdp.cs.OHIOU.EDU> <908@maccs.UUCP>
Organization: The Unix(R) Connection, Dallas, Texas
Lines: 34
Keywords: clock leading edge pc
Summary: Call Leading Edge Bulletin Board

In article <908@maccs.UUCP>, darel@maccs.UUCP (Darel Mesher) writes:
> In article <651@pdp.cs.OHIOU.EDU> shapiro@oucs.UUCP writes:
> >
> >I have recently installed a new 30MB drive into my fathers Leading Edge
> >model D. When I installed his new version of MS-DOS 3.2 (not IBM PC-DOS)
> >I found that his clock is no longer read automatically at boot up.
> > 
> >Does anyone on the net have a program that will read the clock on the Leading
> >Edge model D? 
> > 
> >Brian.
> 
>    Since the Leading Edge PC and the SPERRY PC are the same Mitsubishi box 
> marketed by two different corporations, the following utility should work
> without modification.

I think the person making the original request was looking for a program
for the Leading Edge, Model D.  As far as I know, Sperry did not sell a
PC that is the same as the Model D.  I believe you are thinking of the
Model M (M is for Mitsubishi), which is the same as the Sperry, but with 
a different label.

I have a Model M and had the same problem when I upgraded to DOS 3.2.  I
called the Leading Edge support line (1-800-343-6857) and they told me
the name of the program I needed, which was available on their bulletin
board (1-617-444-9264).  The bulletin board had a clock reading program
for the Model D also.  By the way, as I recall the program I needed had
a different name than the one given to me from the 800 number, so a little
patience may be required.

-- 
	Don Simoneaux		Phone:  (214) 964-1859
	3605 Interlaken Dr.
	Plano, TX 75075		USENET:  ...ihnp4!killer!dons