Path: utzoo!mnetor!uunet!husc6!uwvax!colby!planting
From: planting@colby.WISC.EDU ( W. Harry Plantinga)
Newsgroups: comp.sys.mac
Subject: Re: Bug in Mac Word 3.01?
Message-ID: <4924@spool.cs.wisc.edu>
Date: 21 Dec 87 19:50:01 GMT
References: <1832@optilink.UUCP>
Sender: news@spool.cs.wisc.edu
Reply-To: planting@colby.WISC.EDU ( W. Harry Plantinga)
Organization: U of Wisconsin CS Dept
Lines: 27

In article <1832@optilink.UUCP> cramer@optilink.UUCP (Clayton Cramer) writes:
>I've noticed a bug in the Macintosh version of Word 3.01, and I'm curious
>If you print a document with a table of contents, and ask Word to print the
>document back-to-front, it prints only the sections after the table of
>contents section.

I've noticed this bug.  I print front-to-back.  You could also try specifying
the page numbers you want printed, including section numbers:  in my case,
from 1s1 to 56s3.  That would print from section one, page one to section
three, page 56.

I was bitten by an even stranger bug today.  I set up a paper to print on
the laserwriter and printed part of it to a file.  I then quit, selected
the imagewriter, and tried to print part of the paper.  Every line that
printed had a 0 (zero) on either side of it!

	0It looked something like this.0

The only way I could find to make it stop doing that was to reboot and shift-
repaginate.

Do y'all still find lots of bugs in word 3.01?  I must run across a couple 
every week.  Formulas that don't print, keystrokes missed, bombs, . . .

Harry Plantinga
planting@cs.wisc.edu
{allegra,seismo,ihnp4}!uwvax!planting