Path: utzoo!mnetor!uunet!husc6!rutgers!bellcore!faline!ulysses!gamma!mibte!edsdrd!rel!bob
From: bob@rel.eds.com (Bob Leffler)
Newsgroups: comp.unix.xenix
Subject: Re: *** XENIX on 8086 based Machine ??
Message-ID: <490@rel.eds.com>
Date: 18 Dec 87 02:06:45 GMT
References: <445@m10ux.UUCP>
Organization: Electronic Data Systems, GM Truck & Bus Account
Lines: 16
Summary: Xenix86

In article <445@m10ux.UUCP>, ssa@m10ux.UUCP (MHx5859 ) writes:
> 	Does any versin of Xenix run on a 8086 machine. (in particular
> 	AT&T 6300).  And if so what are the requirements?


Yes, SCO has Xenix86 which has version available for the IBM XT and the
AT&T 6300.  However, SCO is in the process of dropping the support for
this product.  The release level for Xenix86 is 2.1.3, whereas the Xenix286
product is at 2.2.x.

It need 640k of memory and takes up a little over 9mb of disk.

-- 
Bob Leffler - Electronic Data Systems, GM Truck & Bus Account
bob@rel.eds.com or {rutgers, cbosgd!edstb, philabs!fmsrl7}!rel!bob
Opinions expressed may not be those of my employer.