Path: utzoo!utgpu!water!watmath!clyde!rutgers!cmcl2!nrl-cmf!ames!think!bloom-beacon!gatech!mcnc!uvaarpa!umd5!vrdxhq!vsedev!ron
From: ron@vsedev.VSE.COM (Ron Flax)
Newsgroups: comp.protocols.tcp-ip.ibmpc
Subject: Can't use KA9Q with 9.6Kbps Telebit, but can use 9.6K hard
	 wired line.
Message-ID: <1042@vsedev.VSE.COM>
Date: 25 Jan 88 17:02:50 GMT
Reply-To: ron@vsedev.VSE.COM (Ron Flax)
Organization: VSE Software Development Lab
Lines: 13

The subject pretty much sums things up.. I can connect two machines at
9600 baud over a hardwired connection just fine, but when I put two
Telebit Trailblazer modems in between I am unable to establish a
session of any kind.  The modems are set up in PEP mode, but ALL
asynchronous protocols have been disabled.  I have tried setting data
compression on/off, but there is no difference.  I can however use the
modems with tip/cu to dial each computer and work interactively at
9600 baud, but I cannot get a SLIP connection to work.

--
ron@vsedev.vse.com	(Ron Flax)
uucp:	..!uunet!vsedev!ron
inet:	vsedev!ron@uunet.uu.net