Xref: utzoo unix-pc.general:186 comp.sys.att:2149
Path: utzoo!mnetor!uunet!seismo!sundc!pitstop!sun!amdcad!ames!ll-xn!mit-eddie!bloom-beacon!gatech!ufcsv!codas!wrcola!kathy
From: kathy@wrcola.UUCP (Kathy Vincent)
Newsgroups: unix-pc.general,comp.sys.att
Subject: Re: switching back from dial pulsing to touch tone
Message-ID: <1065@wrcola.UUCP>
Date: 9 Jan 88 02:16:27 GMT
References: <1061@wrcola.UUCP> <206@icus.UUCP>
Reply-To: kathy@wrcola.UUCP (Kathy Vincent)
Organization: AT&T, Winston-Salem, NC
Lines: 16
Keywords: how to switch, dial pulse, touch tone

In article <206@icus.UUCP> lenny@icus.UUCP (Lenny Tropiano) writes:
>In article <1061@wrcola.UUCP> kathy@wrcola.UUCP (Kathy Vincent) writes:
>|>
>|>This person's UNIX pc (3.51) had been happily dialing out touch tone
>|>and receiving calls - until one day when it stopped accepting calls
>|>and started dialing dial pulse ... 
>|>
>[suggestions]


Thanks for the suggestions I've been getting so far.
A comment, tho.  I guess I should have made it clear that
this guy *did* go to install and redo the hardware setup - everything
is, according to that, set up his phone lines for touchtone dialing.  

Kathy