Path: utzoo!mnetor!uunet!husc6!bu-cs!coxeng1!root
From: root@coxeng1.UUCP (John R. Petersen)
Newsgroups: comp.sys.tandy
Subject: Re: TRS-80 MOD I. How do I...
Message-ID: <32@coxeng1.UUCP>
Date: 14 Jan 88 20:44:02 GMT
References: <21505@linus.UUCP> <3208@psuvax1.psu.edu>
Reply-To: jrp@coxeng1.UUCP (John R. Petersen)
Organization: Cox Engineering Co., Brighton Mass.
Lines: 10
Keywords: NEWDOS/80 Model I
Summary: NEWDOS/80 No longer available or supported by manufacturer.

In article <3208@psuvax1.psu.edu> wcf@psuhcx (William C. Fenner) writes:
>The drives should be connected by a ribbon cable, with an edge card connector
>on the end.  You have to plug this edge card connector onto an edge card on
>the back of the Expansion Interface. Sorry I can't get more specific than
>that, but I have a non-Tandy EI.  You will need a DOS, if you don't have one.
>My suggestion is Newdos/80.  It's one of the most popular operating systems
>for the TRS80.

NEWDOS/80 is no longer sold or supported by Apparat Inc.  You may still'
find some vendors that have it available tho'