Path: utzoo!utgpu!water!watmath!clyde!rutgers!psuvax1!psuhcx!wcf
From: wcf@psuhcx (Bill Fenner)
Newsgroups: comp.sys.tandy
Subject: Re: Help wanted with ancient TRS80 Model I
Keywords: TRS80 Model I Single Density Disk Drive Help Needed
Message-ID: <3247@psuvax1.psu.edu>
Date: 24 Jan 88 21:03:50 GMT
References: <4480@ecsvax.UUCP>
Sender: netnews@psuvax1.psu.edu
Reply-To: wcf@psuhcx (Bill Fenner)
Distribution: na
Organization: Penn State University, University Park, PA
Lines: 10

Since the drive motor goes on with the connector the one way, that's the
way you want it.  However, you are probably using the wrong connector.
The motor for all 4 drives goes on when one drive is turned on.  So try
each of the other connectors.  Also, have you got your terminating resistor
in the drive?

   __      _  _      _____   Bill Fenner      wcf @ psuhcx.bitnet
  /  )    // //       /  '                    wcf @ hcx.psu.edu
 /--<  o // //     ,-/-, _  __  __  _  __     ihnp4!psuvax1!psuhcx.bitnet!wcf
/___/_<_</_</_    (_/   </_/ <_/ <_</_/ (_