Path: utzoo!utgpu!water!watmath!clyde!rutgers!uwvax!dogie!uwmcsd1!ig!agate!ucbvax!ucdavis!iris!hildum
From: hildum@iris.ucdavis.edu (Eric Hildum)
Newsgroups: comp.os.vms
Subject: Re: LIB$ functions from C
Keywords: how do you do it?
Message-ID: <1129@ucdavis.ucdavis.edu>
Date: 14 Feb 88 01:29:27 GMT
References: <339@dalcsug.UUCP>
Sender: uucp@ucdavis.ucdavis.edu
Reply-To: hildum@iris.UUCP (Eric Hildum)
Organization: U.C. Davis - College of Engineering
Lines: 21

Hello.

About passing parameters to the run time library functions, the
following documents may be of use:

Programming in VAX C (AA-L370B-TE)	Chapter 14

VAX/VMS Run-Time Library Routines Reference Manual (AA-Z502C-TE)
					Part 1	Section 1-2

Guide to Creating Modular Procedures on VAX/VMS (AA-FB84A-TE)

Introduction to VAX/VMS System Routines (AA-Z500B-TE)

Please take the time to look these over, as they will answer almost
all questions you could have about calling routines on VAX/VMS.

				Eric
				dehildum@ucdavis.ucdavis.edu	(Internet)
				dehildum@ucdavis.bitnet	(BITNET)
				ucbvax!ucdavis!dehildum	(uucp)