Path: utzoo!mnetor!uunet!husc6!mit-eddie!ll-xn!ames!necntc!dandelion!ulowell!dino!miner
From: miner@dino.cpe.ulowell.edu (Rich Miner)
Newsgroups: comp.sys.amiga
Subject: Re: Flicker fixer
Message-ID: <1932@dino.cpe.ulowell.edu>
Date: 8 Feb 88 05:53:35 GMT
References: <1868@leo.UUCP>
Reply-To: miner@dino.cpe.ulowell.edu (Rich Miner)
Organization: University of Lowell
Lines: 19

In article <1868@leo.UUCP> harald@leo.UUCP ( Harald Milne) writes:
>... the flicker fixer uses a 9 pin connector (DB9?). This means a
>new cable for all you owners of Multi-whatever scan monitors need a new
>cable, or modify your existing one. They said Redmond Cable has the
>pinout information, and are refering all customers to them. 

The cable will need a male DB9 on the Flicker Fixer end with the pinout:
       Pin  Signal
       ---  ------
	1   Red	   0.7 Volt into 75 Ohm
	2   Green  0.7 Volt into 75 Ohm
	3   Blue   0.7 Volt into 75 Ohm
	4   Horizontal Sync - Negative going TTL
	5   Vertical Sync - Negative going TTL
	6-9 Ground

This is the configuration on the beta-boards, I have been told it is frozen.
-- 
Rich miner@ulowell.edu  617/452-5000x2693  ULowell CPE Imaging Research Lab