Path: utzoo!utgpu!water!watmath!clyde!rutgers!rochester!ur-tut!sunybcs!boulder!hao!oddjob!uwvax!dogie!uwmcsd1!lakesys!rich
From: rich@lakesys.UUCP (Rich Dankert)
Newsgroups: comp.sys.atari.st
Subject: Re: Tried to 1 meg, problem
Message-ID: <446@lakesys.UUCP>
Date: 13 Feb 88 03:27:07 GMT
References: <113chad@byuvax.bitnet>
Reply-To: rich@lakesys.UUCP (Rich Dankert)
Organization: Lake Systems, Milwaukee, WI
Lines: 25

In article <113chad@byuvax.bitnet> chad@byuvax.bitnet writes:
>
>I just finished putting in sockets, the capacitors, and 2 resistors
>on my 520STfm motherboard (rev D) where it normally is in a 1040.

	Two --> resistors ??? <--

	I just completed a 520STfm upgrade. Used sockets, caps and of course 
chips. No resistors though.  Where did you put the resisors ??? I also did 
the upgrade on a Rev D board. 

>
>Now, with or without the sockets populated, you turn the machine on, it
>displays that typical blank screen for boot but with a white stripe
>going across it about 2/3 or 3/4 of the way down from the top
>
	Sounds like you ZAPed someting while you were working on the upgrade.
I would look into the MMU if I were you. You may have toasted it. Sounds like 
what your seeing is some words placed on the screen. A friend of mine had this
with his upgrade board, and the problem WAS the MMU. Replaced and allis fine.

-rich
UUCP: {Ihnp4,uwvax}!uwmcsd1!lakesys!rich
Discalimer: The words,ideas,and expressions are my own, and not nessasarily 
always correct, so don't hold me to it!