Path: utzoo!mnetor!uunet!lll-winken!csustan!polyslo!csun!sdcrdcf!trwrb!scgvaxd!ashtate!dbase!drc
From: drc@dbase.UUCP (Dennis Cohen)
Newsgroups: comp.sys.mac
Subject: Re: macii programmers button
Message-ID: <299@dbase.UUCP>
Date: 4 Feb 88 13:57:27 GMT
References: <14270@oliveb.olivetti.com>
Organization: Ashton Tate Development Center Glendale Cal.
Lines: 18
Keywords: help
Summary: No such section

In article <14270@oliveb.olivetti.com>, arms@oliveb.olivetti.com (Steve @ His Desk) writes:
> Could someone MAIL me the instructions to install the programmers
> button on the MacII. I cant seem to find the appropreate section
> in the manual. Thanks for any help.


This isn't mail, but it's a question that arises with fair frequency, so I will
answer it on the net (as a few others have before me).  The Mac II programmer's
switch mounts on the right side of the II (as you face it).  It mounts in the
vents about 80% of the way back -- below where the hard disk mounts.  The
reason that you can't find the appropriate section in the manual is that the
appropriate section DOES NOT EXIST.  Apple either forgot (or more likely)
purposely did not document this.

Dennis Cohen
Ashton-Tate Glendale Development Center
dBASE Mac Development Team
--------------------------
Disclaimer:  The opinion(s) expressed above are _mine_!