Path: utzoo!mnetor!uunet!lll-winken!lll-lcc!pyramid!nsc!csi!jwhitnel
From: jwhitnel@csi.UUCP (Jerry Whitnell)
Newsgroups: comp.sys.mac
Subject: Re: macii programmers button
Message-ID: <1401@csib.csi.UUCP>
Date: 9 Feb 88 00:12:12 GMT
References: <14270@oliveb.olivetti.com> <299@dbase.UUCP>
Reply-To: jwhitnel@csib.UUCP (Jerry Whitnell)
Organization: Communications Solutions Inc., San Jose, Ca
Lines: 25
Keywords: help

In article <299@dbase.UUCP> drc@dbase.UUCP (Dennis Cohen) writes:
>
>This isn't mail, but it's a question that arises with fair frequency, so I will
>answer it on the net (as a few others have before me).
Unfortunatly, it's usually people who are putting together their Mac II for the
first time so they havn't read this group before.  

>The Mac II programmer's
>switch mounts on the right side of the II (as you face it).  It mounts in the
>vents about 80% of the way back -- below where the hard disk mounts.  The
>reason that you can't find the appropriate section in the manual is that the
>appropriate section DOES NOT EXIST.  Apple either forgot (or more likely)
>purposely did not document this.

It helps to take off the top.  Looking down, on the side opposite the
power supply (the gold box) you'll see two buttons mounted on a stand
facing the side of the Mac II.  They are towards the back of the mother
board, near the last of the air slots on that side.

>
>Dennis Cohen


Jerry Whitnell				Been through Hell?
Communication Solutions, Inc.		What did you bring back for me?
						- A. Brilliant