Path: utzoo!mnetor!uunet!seismo!sundc!pitstop!sun!decwrl!fstvax.dec.com!gallo
From: gallo@fstvax.dec.com (All You Zombies...)
Newsgroups: comp.lang.c
Subject: Aztex Shell v2.4 help needed
Message-ID: <8802110045.AA18395@decwrl.dec.com>
Date: 11 Feb 88 00:45:32 GMT
Organization: Digital Equipment Corporation
Lines: 31


	   I'm not sure whether this is the proper place,but here goes....

   I am running an apple dos 3.3 version of AZTEC C.It has the Version
   2.4 shell.I recently purchhased an Apple Disk 3.5 disk drive.The dod
   3.3 software partitions my 3.5 into two 400K partitions drive #1 and
   Drive #3.If I access the 3.5 from the dos prompt,I can access both 
   partitions .If I try to use the shell,I cannot access the second
   partition.

   The question is: 
   
    Is there someone else out there running AZTEC C (Dos 3.3,Apple) on
    a disk 3.5 that can provide some patches to allow the shell to 
    access drive units other that 1 and 2.



    BTW,This was also posted to comp.sys.apple.

      THank you very much,

         Tom Gallo

			      Tom Gallo (/tomg)

*************************************************************************
**                                                                     **
** The opinions expressed here are my OWN and not those of my employer **
**                                                                     **
*************************************************************************