Path: utzoo!utgpu!water!watmath!clyde!rutgers!sunybcs!ugfailau
From: ugfailau@sunybcs.uucp (Fai Lau)
Newsgroups: comp.sys.ibm.pc
Subject: Re: Procomm 2.4.2 Question
Message-ID: <8639@sunybcs.UUCP>
Date: 18 Feb 88 10:37:09 GMT
References: <4114@ptsfa.UUCP> <6137@iuvax.UUCP> <4122@ptsfa.UUCP>
Sender: nobody@sunybcs.UUCP
Reply-To: ugfailau@joey.UUCP (Fai Lau)
Organization: SUNY/Buffalo Computer Science
Lines: 17

In article <4122@ptsfa.UUCP> res@ptsfa.UUCP (1140galaxy-Bob Stockwell) writes:
>
>I tried Mark/Release.
>It hung my machine.
>However, I was able to do a warm reboot, 
>which did not hang up my modem.
>So your suggestion worked, sort of???
>
	A quick and dirty way is to disconnect the phone line from
Procomm. Exit Procomm, do whatever you want, and boot Procomm back up
when you're done. Reconnect the phone line and do a alt-P to set the
line and you can pick up whatever you left off.

Fai Lau
SUNY at Buffalo (The Arctic Wonderland)
UU: ..{rutgers,ames}!sunybcs!ugfailau
BI: ugfailau@sunybcs INT: ugfailau@joey.cs.buffalo.EDU