Path: utzoo!mnetor!uunet!lll-winken!lll-lcc!lll-tis!ames!nrl-cmf!mailrus!tut.cis.ohio-state.edu!bgsuvax!ritzenth
From: ritzenth@bgsuvax.UUCP (Phil Ritzenthaler)
Newsgroups: comp.sys.ibm.pc
Subject: Re: UNIX to PC binary file transfer (HELP)
Message-ID: <1593@bgsuvax.UUCP>
Date: 25 Feb 88 18:03:52 GMT
References: <4433@sigi.Colorado.EDU>
Distribution: na
Organization: The Land Beneath the Forest Moon of Endor
Lines: 28
Summary: using kermit

In article <4433@sigi.Colorado.EDU>, murillo@sigi.Colorado.EDU (Rodrigo Murillo) writes:
> Could someone tell me how to transfer files from unix to the PC?
> I am running PC-VT on my PC and kermit (of course) on the unix side.
> PC-VT allows you to shell to MS-KERMIT.  I can't seem to get the
> sequence of events down...  Any suggestions would be greatly
> appreciated.


1.)  bring up C-Kermit on unix
1.5) change packet size if you want (recommended 500-1000 bytes)
2.)  If the file is binary, at the C-Kermit prompt type:
         set file type binary
3.)  next type:
         send <filename>
     replacing <filename> with your file name you want to send
4.)  go BACK to PC-VT
5.)  drop to MS-KERMIT
5.5) set packet size to same as unix if you changed it
6.)  type in:
         rec

MS-Kermit should do the rest . . . good luck!

-- 
Phil Ritzenthaler			|USnail: University Computer Services
Computer Graphics Research Consultant   |        241 Math-Science Bldg.
UUCP :.!cbosgd!osu-cis!bgsuvax!ritzenth |        Bowling Green State University
CSNET: ritzenth@bgsu.edu                |        Bowling Green, OH   43403-0125
ARPA : ritzenth%bgsu.edu@relay.cs.net   | Phone: (419) 372-2102