Path: utzoo!mnetor!uunet!lll-winken!lll-lcc!ames!ucsd!sdcsvax!net1!borton From: borton@net1.ucsd.edu (Chris Borton) Newsgroups: comp.sys.mac Subject: Re: Using a mac in a 220V/50Hz environment Message-ID: <4685@sdcsvax.UCSD.EDU> Date: 2 Mar 88 07:37:43 GMT References: <1073@pembina.UUCP> <23120@ucbvax.BERKELEY.EDU> <2534@usceast.UUCP> Sender: nobody@sdcsvax.UCSD.EDU Reply-To: borton@net1.UUCP (Chris Borton) Organization: UCSD Network Operations Group Lines: 28 Keywords: portability, power supply I brought my 128K->512K->2M Mac to Germany last year with my ImageWriter I and Apple HD20; all worked on a 250W transformer with no problems whatsoever. Technically the HD20 didn't need the transformer--it takes 70-270V, but I wasn't about to tamper with a working system. The ImageWriter I had no complaints--according to official Apple specs, it is the IW II that is cycle-dependent. Has anyone verified this? The reason I question this is that under the same listing of cycle-dependent was the LaserWriter, and the institute where I worked had a U.S. LW (later upgraded to a Plus) running off a transformer, no cycle conversion, without a hitch. Ignorance is bliss, I guess... On the Int'l vs. U.S. analog boards: yes indeed, there are two. I learned the hard way. Int'l is manufactured in Ireland, source of all the European Macs, and has one jumper (W12 if I remember correctly--it's labelled 120/220V) that decides what voltage. BEWARE--the U.S. analog board has the same jumper, in the same place, with a DIFFERENT function!!! Like I said, I learned the hard way. That ambiguous point caused me much, much grief... Thank goodness Apple has set a new wonderful direction with the SE/II power supplies! Now if only they'd do that for my ImageWriter II... Any comments about the new LaserWriters? -cbb Chris "Johann" Borton, UC San Diego ...!sdcsvax!borton borton@ucsd.edu or BORTON@UCSD.BITNET Letztes Jahr in Deutschland, nog een jaar hier, en dan naar Amsterdam! "H = F cubed. Happiness = Food, Fun, & Friends." --Steve Wozniak