Path: utzoo!mnetor!uunet!mcvax!ukc!dcl-cs!bath63!sc_mjlo
From: sc_mjlo@ux63.bath.ac.uk (Miles Osborne)
Newsgroups: comp.sources.d
Subject: Spread Sheet Calculator ( by Robert Bond)
Message-ID: <2227@bath63.ux63.bath.ac.uk>
Date: 1 Mar 88 15:40:51 GMT
Reply-To: sc_mjlo@ux63.bath.ac.uk (Miles Osborne)
Organization: University of Bath, England
Lines: 22

I have a couple of queries concerning the spreadsheet calculator program.

i) Defining variables - I have realised that these can be defined by directly
editing the spreadsheet file- but can they be set whilst in the spreadsheet
program and saved afterwards all I seem to be able to do is set them but they
won't save when I quit out of the program and I can't seem to change them
once they have been set. Also again concerning defining variables when I placed
them in the spreadsheet file there did seem to be a limit of about 8 definitions
am I correct in that, and if I am is there anyway of getting round that limit.

ii) Macros - Can anyone give me a better idea than the man page does on what
these should look like and how they can be used.

iii) Is there anyway other than the goto command of going down say 20 lines
or across 20 lines etc.

Well thats just about it I look forward to any comments on the above.
-- 
 Miles Osborne                |  tel : Bath 826982
 SWURCC,Bath University,      |  UUCP:..!uunet!mcvax!ukc!bath63!sc_mjlo
 Claverton Down,Bath, Avon    |
 England BA2 7AY              |