Path: utzoo!utgpu!water!watmath!clyde!att-cb!att-ih!pacbell!ptsfa!ames!amdahl!uunet!nuchat!peter
From: peter@nuchat.UUCP (Peter da Silva)
Newsgroups: comp.sys.amiga
Subject: Re: DME Executing make, is it possible?
Message-ID: <723@nuchat.UUCP>
Date: 3 Mar 88 03:02:12 GMT
References: <8802290540.AA21325@cory.Berkeley.EDU>
Organization: Public Access - Houston, Tx
Lines: 13

In article ... dillon@CORY.BERKELEY.EDU (Matt Dillon) writes:
> 	Did you run DME from the workbench or the CLI?  DME simply
> calls Execute() to implement execute, and that doesn't work if DME was
> started up from the workbench.

Browser and Eceute get along just fine if it's started from the Workbench.
But not if it's RunBack-ed. I'm in the process of doing up a replacement
for RunBack that should solve that problem. Anyway, what I do is create
a command file and Execute "NewCLI CON:whatever FROM file".
-- 
-- a clone of Peter (have you hugged your wolf today) da Silva  `-_-'
-- normally  ...!hoptoad!academ!uhnix1!sugar!peter                U
-- Disclaimer: These aren't mere opinions... these are *values*.