Path: utzoo!mnetor!uunet!husc6!bbn!uwmcsd1!csd4.milw.wisc.edu!jon
From: jon@csd4.milw.wisc.edu (Jon George Seidl)
Newsgroups: comp.sys.cbm
Subject: C64 hardware reset
Message-ID: <5061@uwmcsd1.UUCP>
Date: 4 Mar 88 21:32:53 GMT
Sender: daemon@uwmcsd1.UUCP
Reply-To: jon@csd4.milw.wisc.edu (Jon George Seidl)
Organization: University of Wisconsin-Milwaukee
Lines: 17

Hi,

I'm looking for a way to reset my C64 to power-up state without turning it
off and on. It should be a hardware reset (a little red button or something).
Is there "gentle" way to do this (like temporarily opening a low-current
connection someplace that won't fry chips after a few uses)? If so, are there
schematics out there for doing this? I've seen something like this on cartridge
expansion port modules.

							Jon
---------------
					
    \_/ \/\/ - /\/\ilwaukee	           "Oh these? umm...	
				               no, nothing kinky like
 Internet: jon@csd4.milw.wisc.edu	          that, they're just...
   bitnet: jon%csd4.milw.wisc.edu@wiscmac3.bitnet     ummm...souvenirs."
     Uucp: uwvax!uwmcsd1!uwmcsd4!jon