Path: utzoo!mnetor!uunet!husc6!mailrus!nrl-cmf!ames!pasteur!ucbvax!uclachem.UUCP!uucp
From: uucp@uclachem.UUCP (Unix-to-Unix copy program)
Newsgroups: comp.unix.microport
Subject: Submission for comp-unix-microport
Message-ID: <8803081612.AA01561@uclachem.chem.ucla.edu>
Date: 8 Mar 88 16:12:28 GMT
Sender: daemon@ucbvax.BERKELEY.EDU
Lines: 32

Path: uclachem!cepu!trwrb!scgvaxd!wlbr!jplgodo!mahendo!elroy!ames!mailrus!umix!uunet!w3vh!rolfe
From: rolfe@w3vh.UUCP (Rolfe Tessem)
Newsgroups: comp.unix.microport
Subject: Re: MicroPort Unix V/AT
Summary: DOSMerge Installation
Keywords: Help with 286 DosMerge
Message-ID: <308@w3vh.UUCP>
Date: 2 Mar 88 13:56:51 GMT
References: <2495@ihuxv.ATT.COM>
Organization: W3VH Packet Radio Gateway, Great Barrington, MA
Lines: 20

In article <2495@ihuxv.ATT.COM>, bareta@ihuxv.ATT.COM (Benyukhis) writes:
> 
> I desperately need help with installing the System V/AT
> DosMerge on my PC's Limited 286 machine.  It seems to blow up
> at the later stages in the installation.  After the Dos Image is or
> may be is being created it cannot boot of of the hard drive.  I followed
> the installation manual to the letter twice and could not get the
> install to complete.  Is it a disk, drive controller?  If anyone has
> a clue or the answer please respond.

I had the same problem with my clone.  It turns out that
while Unix doesn't really use the BIOS, DOSMerge (as you
might expect) is *very* BIOS sensitive.  I switched to a
Phoenix BIOS and all was well.  Contact your friendly clone
parts dealer -- should cost about $35.00.

-- 
UUCP:  {uunet}!w3vh!rolfe		| Rolfe Tessem
ARPA:  w3vh!rolfe@uunet.UU.NET		| P.O. Box 793
PACKET RADIO: W3VH@WA2PVV		| Great Barrington, MA 01230