Path: utzoo!mnetor!uunet!husc6!hao!ames!pasteur!ucbvax!ANDREW.CMU.EDU!aad+
From: aad+@ANDREW.CMU.EDU ("Anthony A. Datri")
Newsgroups: comp.laser-printers
Subject: Re: TI Omnilaser 2115 cost/page.
Message-ID: <8803161452.AA06723@brillig.umd.edu>
Date: 11 Mar 88 22:44:53 GMT
References: <8803011510.AA00752@brillig.umd.edu>
Sender: usenet@ucbvax.BERKELEY.EDU
Organization: The Internet
Lines: 7
Approved: laser-lovers@brillig.umd.edu

We have found that, when in a pinch, an OPC belt that the Omnilaser thinks
is shot can be kludged into working by replacing the shiny strip with a piece
of a floppy write-protect tab.  This helped when ours refused to work after
having been shipped across the country.

Of course, I don't have these problems with my Omni 810, but then again,
it's a 5x7 matrix without permanent tabs.