Path: utzoo!mnetor!uunet!tektronix!tekcrl!tekgvs!keithe
From: keithe@tekgvs.TEK.COM (Keith Ericson)
Newsgroups: comp.sys.ibm.pc
Subject: Re: 3.5" drive for old PC-1 ?
Message-ID: <3255@tekgvs.TEK.COM>
Date: 24 Mar 88 20:10:50 GMT
References: <797@agora.UUCP> <16800244@clio>
Reply-To: keithe@tekgvs.UUCP (Keith Ericson)
Organization: Tektronix, Inc., Beaverton,  OR.
Lines: 9

With my old PC-1 I installed a 3.5" drive as drive C: by soldering a
ribbon cable to the appropriate pins on the (inside of the) rear panel
connector of the floppy disk controller. It took some time to figure it
all out, and I used a bus wire (16 gauge, I think) bent in a hoop to
solder all the ground wires to. The other end of the ribbon cable was
terminated in the appropriate connector for the drive; it worked and I
was happy with it.

keith