Path: utzoo!utgpu!water!watmath!clyde!rutgers!cmcl2!husc6!mailrus!umix!uunet!tektronix!tekgen!jonh
From: jonh@tekgen.TEK.COM (Jon Howell)
Newsgroups: comp.sys.m6809
Subject: Problems with /t2 & /t3
Summary: Conflicting pak's?
Message-ID: <2617@tekgen.TEK.COM>
Date: 27 Mar 88 23:28:15 GMT
References: <4757@pucc.Princeton.EDU>
Reply-To: jonh@tekgen.UUCP (Jon Howell)
Organization: Tektronix, Inc., Beaverton, OR.
Lines: 23

(Similar article posted to CoCo Listserve discussion)
I have a terminal hooked up to the coco under Os9 level II.  It is in slot
one, with an RS-232 pak.  It runs 19.2 kb.  I also have a modem hooked up
in an RS-232 pak, slot two, running 1200 b.  When I config'ed a disk with
both /t2 and /t3 on it, there was an unacceptable bug:  Anything
sent to either port also appeared on the other port, and at the baud rate of
the intended port.  So, if I sent a string to the modem, then it would get
there OK, but the terminal would display a load of junk which must've been
1200 baud, since one string expanded to half a screen on the terminal.  Also,
sending anything to the terminal causes the modem lights to flicker at 19.2kb.
(They of course don't recieve anything.)
Can anyone tell me what I can do to fix this problem?  Send new dd's, if I need
them.  (I know ~zilch about device drivers/descriptors) I can't use /t1 for the
modem because it slows the system almost to a halt, and I also want my printer
online.
		Thanks in advance,
			Jon
 
-- 
/\/\ | / |/ /_ \/  /\/\ /\ |  | (  /_   | (   |\ /_ /\ |\ |
|| | | \ |\ \  |   || | \/ \__/  ) \    |  )  |/ \  || |/ *
...tektronix!tekgen!jonh        USnail: 185 Norton, Sherwood OR 97140
Nutri-Grain is for the birds.   MaBull: 503 MAK-SEMA (!)