Xref: utzoo comp.sys.apple:4911 comp.sys.mac.programmer:326
Path: utzoo!mnetor!uunet!husc6!mailrus!umix!nancy!eecae!super.upenn.edu!dsl.cis.upenn.edu!neil
From: neil@dsl.cis.upenn.edu (Neil Radisch)
Newsgroups: comp.sys.apple,comp.sys.mac.programmer
Subject: Super Serial Card problem
Message-ID: <3765@super.upenn.edu>
Date: 25 Mar 88 18:08:28 GMT
Sender: news@super.upenn.edu
Reply-To: neil@dsl.cis.upenn.edu.UUCP (Neil Radisch)
Distribution: comp.sys.apple,comp.sys.mac.programmer
Organization: University of Pennsylvania
Lines: 18

I am trying to hook my apple 2 to my mac via a SSC in the apple and the
printer port of the mac.
My problem is that when I send a Data Terminal not ready from my apple
to the mac, the mac still sends between two and three characters which
get lost by the apple 2 since the Data Terminal not ready signal on the
SSC also disables the receive register on the SSC.
The mac is working properly since the imagewriter manual says that the
printer can receive up to 30 characters after sending Data Terminal not
ready.

Ok you gurus.......any solutions ?

|----------------------------------------------------------------------------|
| "Better to remain quiet and be thought a fool than to speak out and remove |
|  all doubt" --- Abraham Lincoln                                            |
|                                                                            |
|  neil@dsl.cis.upenn.edu.UUCP                                               |
|----------------------------------------------------------------------------|