Path: utzoo!mnetor!uunet!ndsuvax!ncegeber
From: ncegeber@ndsuvax.UUCP (Roger Egeberg)
Newsgroups: comp.unix.microport
Subject: Re: Tracking down system panics.
Message-ID: <739@ndsuvax.UUCP>
Date: 23 Mar 88 15:50:34 GMT
References: <320@w3vh.UUCP>
Reply-To: ncegeber@ndsuvax.UUCP (Roger Egeberg)
Followup-To: comp.unix.microport
Organization: North Dakota State University  Fargo, ND
Lines: 18
Keywords: Microport System V/AT

In article <320@w3vh.UUCP> rolfe@w3vh.UUCP (Rolfe Tessem) writes:
>I've been plagued by double panics lately on my System V/AT clone-based
>system, and I was grateful to see John Plocher's very explicit information
>on what to do with the register dump to track down the problem.  My panics
>...

I also followed the instructions given a few days ago.  My last two crashes
both happened in 'clkint1'.  Does anybody know what this routine does?  My
crashes don't appear to be related to serial communications - I'm using
Bell Technologies' HUB6 card with their drivers.

I should also say that the micro is a Bell Tech MPE (Tatung AT-clone) running
at 8 MHz, with 4 Meg RAM, a 72 Meg hard disk, and the previously mentioned
HUB6 card.

-- 
Roger Egeberg                 USENET:    ncegeber@ndsuvax.UUCP
NDSU Extension Service        BITNET:    nu062423@ndsuvm1.BITNET