Path: utzoo!mnetor!uunet!husc6!ncar!gatech!hubcap!ncrcae!ncr-sd!ivory!mike
From: mike@ivory.SanDiego.NCR.COM (Michael Lodman)
Newsgroups: comp.unix.xenix
Subject: ansi cursor controls
Message-ID: <325@ivory.SanDiego.NCR.COM>
Date: 21 Mar 88 18:32:08 GMT
Reply-To: mike@ivory.SanDiego.NCR.COM (Michael Lodman)
Organization: Advanced Development, NCR Corporation, San Diego
Lines: 13

I am using SCO Xenix and I am trying to port some screen tools
which use ansi escape sequences from DOS to Xenix. Unfortunately,
Xenix console does not seem to support the sequence for save and
restore cursor position. Is there a workaround or undocumented
feature I could use  to do this?

-- 
Michael Lodman  (619) 485-3335
Advanced Development NCR Corporation E&M San Diego
mike.lodman@ivory.SanDiego.NCR.COM 
{sdcsvax,cbatt,dcdwest,nosc.ARPA,ihnp4}!ncr-sd!ivory!mike

When you die, if you've been very, very good, you'll go to ... Montana.