Path: utzoo!mnetor!uunet!lll-winken!lll-tis!ames!ncar!boulder!cu-den!udenva!rbourass
From: rbourass@udenva.cair.du.edu (Mr. Photography)
Newsgroups: comp.sys.ibm.pc
Subject: Need help with "Time"
Message-ID: <10152@udenva.cair.du.edu>
Date: 8 Apr 88 22:58:52 GMT
Organization: Univ. of Denver, CO, USA
Lines: 32


	Just replaced my DTK XT motherboard with a DTK Baby 286
motherboard.  Everything running well with one exeption. DOS is not
picking up the time from the built in clock.  As with most 286 boards,
there is a built in clock and a setup utility.  The board is holding and
maintaining the correct time and date, but DOS only reads the date.
Typing 

C:\> time <RET>

results in a value in hours and minutes that reflects how long it has
been since the last power-up or reboot.

The "date" function works fine.

SYSTEM:

DTK 6/10 Mhz Baby 286
1024 K
Multi I/O Card (Floppy cont, Serial, Parallel, Game, disabled clock/cal)
(2) 360k Drives
CGA w/parallel
Plus HardCard 20 with 286 rom upgrade

Any help will be greatly appreciated!
Please respond via E-mail to:

rbourass@udenva

Thanks again!
Rich

a